Module data
Arduino
Motor controllers
Timer relay
This is an old revision of the document!
Published 12 Oct 2026
Dual/Stepper Motor Controller Module
| Module Description | |
|---|---|
| Model | XC4492 |
| Manufacturer | Duiotech |
| Description | Dual/Stepper Motor Controller Module |
| Other designations | TA0052 iduino L298 , Keyes L298, Keyestudio L298N |
| Associated modules | - |
| Voltage | 3V - 30V |
| Current | 4A max total load |
Overview
It uses the L298N Dual Motor Driver chip to provide full control of two DC motors or a single stepper-motor.
Hardware description
Components
- L298N, Dual full-bridge driver
Features
- 3V DC - 30 V DC operating voltage
- 2A peek current per motor channel
- Back-EMF protection
- Over-temperature protection
- On-board 5V regulator can provide power to Arduino etc (if supplied operating voltage <16V)
- Status LEDs (logic power and input status)
- Provision for current sense resistors
Revisions
Schematics
| XC4492 circuit schematic : |
|---|
| Jumper block | |
|---|---|
| CSB | Insert current sense resistor between pins to measure current on channel B, or short with jumper if not used |
| CSA | Insert current sense resistor between pins to measure current on channel A, or short with jumper if not used |
| UR1 | Jumper to activate pullup on IN4 (not needed for Arduino) |
| UR2 | Jumper to activate pullup on IN3 (not needed for Arduino) |
| UR3 | Jumper to activate pullup on IN2 (not needed for Arduino) |
| UR4 | Jumper to activate pullup on IN1 (not needed for Arduino) |
| 5V_EN | Jumper to enable +5V power to the board via 5V regulator from VMS supply (only if VMS less than 16V otherwise need to supply external 5V) |
Examples
References and Additional Resources
- XC4492 datasheet.
- L293, L293E and L298 application notes.
- TA0052 datasheet.
- Keyestudio L298N wiki page.
If any referenced page no longer exists, try looking for its URL on http://archive.org.
1)
PAGE UNDER CONSTRUCTION
electronic/boards/xc4492.1791932563.txt.gz · Last modified: 2026/10/13 23:02 by tony
Except where otherwise noted, content on this wiki is licensed under the following license: CC Attribution-Share Alike 4.0 International