Module data
Arduino
Motor controllers
Timer relay
This is an old revision of the document!
Published 12 Oct 2026
Dual/Stepper Motor Controller Module
| Module Description | |
|---|---|
| Model | XC4492 |
| Manufacturer | Duiotech |
| Description | Dual/Stepper Motor Controller Module |
| Other designations | TA0052 iduino L298 , Keyes L298, Keyestudio L298N |
| Associated modules | |
| Voltage | 5V |
| Current | 4A (peek max 2A per channel) |
Overview
It uses the L298N Dual Motor Driver chip to provide full control of two DC motors or a single stepper-motor.
Hardware description
Components
- L298N, Dual full-bridge driver
Features
- 3V DC - 30 V DC operating voltage
- Back-EMF protection
- Over-temperature protection
- On-board 5V regulator can provide power to Arduino etc (if supplied operating voltage <16V)
- Status LEDs (power on and motor direction)
Revisions
Examples
References and Additional Resources
- XC4492 datasheet.
- TA0052 datasheet.
- Keyestudio L298N wiki page.
If any referenced page no longer exists, try looking for its URL on http://archive.org.
1)
PAGE UNDER CONSTRUCTION
electronic/boards/xc4492.1791791993.txt.gz · Last modified: 2026/10/12 07:59 by tony
Except where otherwise noted, content on this wiki is licensed under the following license: CC Attribution-Share Alike 4.0 International