• 16 Columns x 2 rows of text display
• Blue backlight
• 5 Push button keypad (labelled up, down, left, right and reset)
• Contrast control
• Display uses standard 4bit LCD library

Andy Gock mentions on his library page a flaw in the design of the backlight control : “when pin 10 is set to output, and set high, it could cause the IO pin of the MCU (the main Atmel chip) to deliver too much current (over the datasheet’s maximum rating)”. To avoid this:

  To turn the backlight on, set pin 10 as input.
  To turn the backlight off, set pin 10 as output, and immediately set output low (never high!)

From the published schematic I can see that the Arduino D10 drives the base of a transitor directly (with no current limit resistor), this may be the problem he describes.

Suggested fix and light level control. https://www.instructables.com/Arduino-LCD-Backlight-Fix/

XC4454 overview

• DFRobot LCD Keypad Shield (2009)
• DFRobot LCD Keypad Shield Wiki
• Arduino Library for DF Robot 16×2 LCD Keypad Shield (Andy Gock)

If any referenced page no longer exists, try looking for its URL on http://archive.org.