Differences
This shows you the differences between two versions of the page.
| Both sides previous revisionPrevious revision | |||
| electronic:lcd:wdect2315 [2026/09/01 09:12] – tony | electronic:lcd:wdect2315 [2026/09/26 05:50] (current) – tony | ||
|---|---|---|---|
| Line 1: | Line 1: | ||
| + | {{ : | ||
| + | ^ LCD Description | ||
| + | ^Model|**WDECT2315**| | ||
| + | ^Manufacturer|| | ||
| + | ^Recovered from|[[: | ||
| + | ^Board IDs|PE-1917AB| | ||
| + | ^LCD type|positive| | ||
| + | ^Polarizer type|transflective| | ||
| + | ^Columns|16| | ||
| + | ^Rows|3| | ||
| + | ^Char matrix|5x7| | ||
| + | ^Driver IC|(CoG)| | ||
| + | ^Backlight|-| | ||
| + | ^Arduino driver|| | ||
| + | ^Connector|pins| | ||
| + | ^Num Pins|8| | ||
| + | ^Pin spacing|2mm| | ||
| + | |||
| + | ^ Connector pin-out | ||
| + | ^Pin# | ||
| + | ^1|CS|Chip select|active low| | ||
| + | ^2|MOSI|Data|8bits, | ||
| + | ^3|CLK|Data clock|normally low, data clocked on rising edge| | ||
| + | ^4|RS|Register Select|Low = command, High = data| | ||
| + | | | ||
| + | ^5|RST|Reset|0V jumps to 3.24V after short delay on power-up| | ||
| + | ^6|Vcc|3.24v| | ||
| + | ^7|GND|0V|(battery -ve)| | ||
| + | ^8|Vlcd|-2.65v| | ||
| + | Vbat=3.3v | ||
| + | |||
| + | \\ | ||
| + | ---- | ||
| + | ===== Additional info ===== | ||
| + | * {{: | ||
| + | * {{: | ||
| + | |||
| + | \\ | ||
| + | ---- | ||
| + | ===== Examples ===== | ||
| + | |||
| + | {{: | ||
| + | |||
| + | / | ||
| + | |||
| + | {{: | ||
| + | |||
| + | {{: | ||
| + | / | ||
| + | / | ||
| + | |||
| + | {{: | ||
| + | / | ||
| + | / | ||
Except where otherwise noted, content on this wiki is licensed under the following license: CC Attribution-Share Alike 4.0 International