My Projects

You are here: start » electronic » lcd » m299

My Projects

User Tools

Site Tools

You are here: start » electronic » lcd » m299

Differences

This shows you the differences between two versions of the page.

Link to this comparison view

Both sides previous revisionPrevious revision
Next revision		Previous revision
electronic:lcd:m299 [2023/03/04 08:01] – tonyelectronic:lcd:m299 [2026/09/26 08:29] (current) – tony
Line 2: Line 2:
 ^  LCD Description  || ^  LCD Description  ||
 ^Model|**LMCCAT299C**| ^Model|**LMCCAT299C**|
-^Manufacturer|[[https://www.npc.com.tw/j2npc/enus/prodcate/Electronic%20Material|NAN YA Plastics Corp]] (Taiwan)|+^Manufacturer|[[https://web.archive.org/web/20210411170952/https://www.npc.com.tw/j2npc/enus/prodcate/Electronic%20Material|NAN YA Plastics Corp]] (Taiwan)|
 ^Recovered from|Wayfarer TGX 13722 ((Wayfarer Transit Systems Ltd, England))| ^Recovered from|Wayfarer TGX 13722 ((Wayfarer Transit Systems Ltd, England))|
 ^Board IDs|M299- Rev.A, D36072B1J, M299-GA, 36171103M336, LMCCAT299C| ^Board IDs|M299- Rev.A, D36072B1J, M299-GA, 36171103M336, LMCCAT299C|
 ^LCD type|positive| ^LCD type|positive|
 ^Polarizer type|transflective| ^Polarizer type|transflective|
-^Columns|192 pixels|+^Columns|160 pixels|
 ^Rows|128 pixels| ^Rows|128 pixels|
 ^Char matrix|6x8| ^Char matrix|6x8|
-^Driver IC|T6963C|+^Driver IC|[[: electronic:datasheet:toshiba|T6963C]]|
 ^Backlight|yellow-green| ^Backlight|yellow-green|
 ^Arduino driver|U8g2lib.h| ^Arduino driver|U8g2lib.h|
Line 19: Line 19:
  
 ^  Connector pin-out ((based on a similar 160x128 displays))  ^^^| ^  Connector pin-out ((based on a similar 160x128 displays))  ^^^|
-^Pin#^IC pin^Label^Description| +^Pin#^Ribbon cable#((Ribbon cable IDE header is on back to front, so cable pin numbering is mirrored))^IC pin^Label^Description| 
-^1| |FG|Frame Ground| +^1|2| |FG|Frame Ground| 
-^2|63|VSS|Ground| +^2|1|63|VSS|Ground| 
-^3|61|VDD|Supply Voltage for Logic| +^3|4|61|VDD|Supply Voltage for Logic| 
-^4| |VO|(variable) Supply Voltage for LCD| +^4|3| |VO|(variable) Supply Voltage for LCD| 
-^5| |VEE|Negative Voltage Output| +^5|6| |VEE|Negative Voltage Output| 
-^6|18|/WR|Data Write| +^6|5|18|/WR|Data Write| 
-^7|19|/RD|Data Read| +^7|8|19|/RD|Data Read| 
-^8|20|/CE|Chip Enable| +^8|7|20|/CE|Chip Enable| 
-^9|21|C/D|Command Write| +^9|10|21|C/D|Command Write| 
-^10|1|/HALT|Clock Operating Stop Signal| +^10|9|1|/HALT|Clock Operating Stop Signal| 
-^11|2|/RESET|Reset Signal| +^11|12|2|/RESET|Reset Signal| 
-^12|10|DB0|Data Bus Line 0| +^12|11|10|DB0|Data Bus Line 0| 
-^13|11|DB1|Data Bus Line 1| +^13|14|11|DB1|Data Bus Line 1| 
-^14|12|DB2|Data Bus Line 2| +^14|13|12|DB2|Data Bus Line 2| 
-^15|13|DB3|Data Bus Line 3| +^15|16|13|DB3|Data Bus Line 3| 
-^16|14|DB4|Data Bus Line 4| +^16|15|14|DB4|Data Bus Line 4| 
-^17|15|DB5|Data Bus Line 5| +^17|18|15|DB5|Data Bus Line 5| 
-^18|16|DB6|Data Bus Line 6| +^18|17|16|DB6|Data Bus Line 6| 
-^19|17|DB7|Data Bus Line 7| +^19|20|17|DB7|Data Bus Line 7| 
-^20| |NC|No Connection|+^20|19| |NC|No Connection|
  
  
-From a photo of the T6963C pins 3,6,7,9 are tied together, it is not apparent whether they go to Vdd or Vss.  If it is Vss then maximum vertical resolution would be 64 v-dots, which seems a bit small for a 95mm high display, so I'll assume they're all tied to Vdd. +From a photo of the T6963C pins 3,6,7,9 are tied together, it is not apparent whether they go to Vdd or Vss.  If it is Vss then maximum vertical resolution would be 64 v-dots, which seems a bit small for a 95mm high display, so I'll assume they're all tied to Vdd (confirmed by Markus). 
-^Display size selectors (hard wired)|||| +^Display size selectors (hard wired)||| 
-^Pin#^IC pin^Wired^Value| +^Pin#^IC pin^Value| 
-^Dual|54| |1| +^Dual|54|1| 
-^MDS|3| |1| +^MDS|3|1| 
-^MD0|4| |0| +^MD0|4|0| 
-^MD1|5| |0| +^MD1|5|0| 
-=> 80 to 128 vertical dots, from the physical size most likely 128 (16 lines of characters) +=> 80 to 128 vertical dots, from the physical size most likely 128 (16 lines of characters).\\ 
-This is now confirmed from looking at a sample of these displays.+128 is now confirmed.
  
-^Display size selectors (hard wired)||||+^Display size selectors (hard wired)|||
 ^Pin#^IC pin^Value| ^Pin#^IC pin^Value|
 ^MD2|6|1| ^MD2|6|1|
 ^MD3|7|1| ^MD3|7|1|
-=32 character columns (or this would give 80 columns if they're tied low, a bit excessive for this width display and not enough control chips to handle it ) +=32 character columns (or this would give 80 columns if they're tied low, a bit excessive for this width display and not enough control chips to handle it).\\ 
-This is now confirmed from looking at a sample of these displays.+32 is now confirmed.
  
-^Display font size selectors||||+^Display font size selectors|||
 ^Pin#^IC pin^Value| ^Pin#^IC pin^Value|
 ^FS0|8|0| ^FS0|8|0|
 ^FS1|9|1| ^FS1|9|1|
-not sure what FS0 connects to, if Vdd then 5x8 font => 160 horizontal dots, if Vss then 6x8 font =>192 horizontal dots (but again not enough control chips to handle it). +not sure what FS0 connects to, if Vdd then 5x8 font => 160 horizontal dots, if Vss then 6x8 font =>192 horizontal dots (but again not enough control chips to handle it).\\ 
-FS0 apparently does connect to Vss,  from looking at a sample of these displays. So this guess was wrong, it is 192 dots wide. +Markus confirms FS0 is connect to Vss, 6x8 font => 192 dots wide.  But there are not enough driver chips to handle more than 160 columns, so the above analysis is wrong.  From the t6963 datasheet the scanning frequency is independent of font width. 
-\\+So I must conclude that we have only 160 dots across to play with as the driver chips can't handle more. 
 + 
 +A photo of a similar display in a Wayfarer TGX150 shows a text display of 27 columns by 16 rows of 7×8 characters. Actually 26 columns plus 4 pixels wide, so we have a 160 x 128 pixel display.  
 +  
 +{{electronic:lcd:wayfarer-tgx150-standalone-bus-ticket-machine-printing-tickets-a.jpg|Example of similar display installed in a TGX150}} 
 +|web.archive.org/web/20210119204556/https://www.picclickimg.com/d/w1600/pict/154290931017_/Wayfarer-TGX150-Standalone-Bus-Ticket-Machine-Printing-Tickets.jpg 
 + 
 +It turns out, that with the T6963C controller, the graphics pixel addressing mirrors the text rendering display buffer addressing.  A side effect is that in graphics mode it is also only displaying the same number of bits per byte as for displaying text.  So if the display is set to 6 bit (pixel) wide characters, it also only displays 6 bits of every byte in graphics mode.  Anyway the U8G2Lib expects T6963C based displays to have 8x8 font set, so short of re-writing the appropriate U8G2 Library, we need to switch this to 8x8 fonts by tying FS1 to ground.  Markus informs me that we need to lift this pin, rather than just cutting tracks, and then connect it to Vss (to Pin 8, FS0).  
 \\ \\
 ===== Additional info ===== ===== Additional info =====
-  * Chips on board: T6963C, T6A39A (x2) T6A40 (x2) , 74HC40103D, 74HC74D, BA10324AF, MT62C256F-70LL+  * Chips on board: T6963C, T6A39A (x2) T6A40 (100pin)  (x2) , 74HC40103D, 74HC74D, BA10324AF, MT62C256F-70LL
   * Similar to OCM160128-1   * Similar to OCM160128-1
-  * {{https://www.npc.com.tw/j2npc/enus/proddoc/Liquid%20Crystal%20Display%20%28%20Graphic%20module%20%29/LCD%20shortform%20%28Mono%20module%29?docid=F000000520&pdid=F00000052|Nan Ya Mono Graphic LCD list}}+  * Similar to [[https://www.sparkfun.com/datasheets/LCD/DS-G160128STBWW.pdf|Di-Star DS-G160128STBWW]] 
 +  * [[https://web.archive.org/web/20200107220929/http://www.npc.com.tw/j2npc/enus/proddoc/Liquid%20Crystal%20Display%20(%20Graphic%20module%20)/LCD%20shortform%20(Mono%20module)?docid=F000000520&pdid=F00000052|Nan Ya Mono Graphic LCD list]] 
 +  * Explanation of difference in U8GLib and U8G2Lib parameters [[https://github.com/olikraus/u8g2/issues/169]] for T6963 displays
  
 +\\
 ---- ----
-===== Examples : =====+===== Examples =====
  
 {{:electronic:lcd:m299.jpg?800|LMCCAT299C front}} {{:electronic:lcd:m299.jpg?800|LMCCAT299C front}}
Line 84: Line 95:
 |{{:electronic:lcd:.jpg?200|LMCCAT299C pixel layout}} |{{:electronic:lcd:.jpg?200|LMCCAT299C pixel layout}}
 |{{:electronic:lcd:.jpg?800|LMCCAT299C circuit}} |{{:electronic:lcd:.jpg?800|LMCCAT299C circuit}}
- 
-  * [[https://www.picclickimg.com/d/w1600/pict/154290931017_/Wayfarer-TGX150-Standalone-Bus-Ticket-Machine-Printing-Tickets.jpg|Example of similar display installed in a TGX150]] 
  

Page Tools

electronic/lcd/m299.1677916907.txt.gz · Last modified: 2023/03/04 08:01 by tony
CC Attribution-Share Alike 4.0 International Except where otherwise noted, content on this wiki is licensed under the following license: CC Attribution-Share Alike 4.0 International