My Projects

You are here: start » electronic » boards » arduino » megaclone3

My Projects

User Tools

Site Tools

You are here: start » electronic » boards » arduino » megaclone3

Differences

This shows you the differences between two versions of the page.

Link to this comparison view

Both sides previous revisionPrevious revision
Next revision		Previous revision
electronic:boards:arduino:megaclone3 [2026/10/28 07:35] – [Features] tonyelectronic:boards:arduino:megaclone3 [2026/10/28 08:16] (current) – [Overview] tony
Line 15: Line 15:
 ===== Overview ===== ===== Overview =====
  
-This is a budget Arduino Mega R3 clone with a CH340G used as USB-to-serial interface, rather than the ATmega16U2 used in the genuine Arduino Mega R3.  Based around the 16MHz ATmega2560, it is a functionally identical clone of the open source Arduino Mega.+This is a budget Arduino Mega R3 clone with a CH340G used as the USB-to-serial interface, rather than the ATmega16U2 used in the genuine Arduino Mega R3.  Based around the 16MHz ATmega2560, it is a functionally identical clone of the open source Arduino Mega.
  
 It can use most Uno shields, but some may require additional wiring or configuration adjustments due to differences in pin layouts and communication protocols. The Mega has fifty four digital I/O pins and sixteen analog inputs compared to the Uno's fourteen digital I/O pins and 6 analog inputs. It also has much larger memory - 256kB flash memory for the Mega compared to 32kB for the Uno. So in short, a mega version of the Uno.  It can use most Uno shields, but some may require additional wiring or configuration adjustments due to differences in pin layouts and communication protocols. The Mega has fifty four digital I/O pins and sixteen analog inputs compared to the Uno's fourteen digital I/O pins and 6 analog inputs. It also has much larger memory - 256kB flash memory for the Mega compared to 32kB for the Uno. So in short, a mega version of the Uno. 
Line 53: Line 53:
  
 ====== References and Additional Resources ====== ====== References and Additional Resources ======
-  *+  * [[https://www.wch-ic.com/downloads/CH341SER_ZIP.html|Manufacturers website page for CH340G drivers]] 
 +  * {{https://docs.arduino.cc/resources/datasheets/A000067-datasheet.pdf|Mega2560 manual}} 
 +  * {{https://docs.arduino.cc/resources/pinouts/A000067-full-pinout.pdf|Mega2560 pinout details (official)}} 
 +  * {{https://content.arduino.cc/assets/MEGA2560_Rev3e_sch.pdf|Mega2560 schematic}}
  
 <html><small><p>If any referenced page no longer exists, try looking for its URL on <a href="http://archive.org">http://archive.org</a>.</p></small></html> <html><small><p>If any referenced page no longer exists, try looking for its URL on <a href="http://archive.org">http://archive.org</a>.</p></small></html>

Page Tools

electronic/boards/arduino/megaclone3.1793172925.txt.gz · Last modified: 2026/10/28 07:35 by tony
CC Attribution-Share Alike 4.0 International Except where otherwise noted, content on this wiki is licensed under the following license: CC Attribution-Share Alike 4.0 International