My Projects

You are here: start » electronic » boards » arduino » duemilanove

My Projects

User Tools

Site Tools

You are here: start » electronic » boards » arduino » duemilanove

Differences

This shows you the differences between two versions of the page.

Link to this comparison view

Next revision		Previous revision
electronic:boards:arduino:duemilanove [2026/10/18 19:40] – created adminelectronic:boards:arduino:duemilanove [2026/10/22 21:22] (current) – tony
Line 5: Line 5:
 {{ electronic:boards:arduino:pa184370a.jpg?200|Duemilanove overview}} {{ electronic:boards:arduino:pa184370a.jpg?200|Duemilanove overview}}
 ^  Module Description  || ^  Module Description  ||
-^Model|**Arduino Duemilanove**|+^Model|**Duemilanove**|
 ^Manufacturer|Arduino| ^Manufacturer|Arduino|
 ^Brand|Arduino| ^Brand|Arduino|
 ^Clone of|-| ^Clone of|-|
-^Description|Arduino UNO R3 2009| +^Description|2009 Arduino Uno predecessor|
-^Associated modules| |+
 ^Voltage|5V| ^Voltage|5V|
-^Current| | 
  
 ===== Overview ===== ===== Overview =====
 +This Arduino is the predecessor of the Arduino Uno, it differs by having a different USB interface chip (FTDI FT232RL) and a slightly better power selection circuit (selecting between different power supplies available to the Arduino) - see Sarah Mitchell's very good electricalflux.com page referenced below.
 +
 +So in some ways superior to the Uno, it does have a deficit in that the bootloader takes up 2kB vs 0.5kB of the available 32kB of onboard flash ram.  It is possible to use an ISP programmer to replace the bootloader code with Optiboot which basically turns it into a Uno with an FTDI USB interface.
 +
 +Mine was purchased from Jaycar and I don't think it is a genuine original as it doesn't have "made in Italy" on it anywhere.
  
 ===== Features  ===== ===== Features  =====
-  *+  * Microcontroller: ATmega168 or ATmega328 
 +  * Clock Speed: 16 MHz crystal oscillator 
 +  * 14 digital input/output pins (6 can be PWM outputs) 
 +  * 6 analog inputs 
 +  * Operating Voltage: 5V 
 +  * Input Voltage: 7-12V 
 +  * 3.3V Power Out: up to 50 mA 
 +  * 5V Power Out: up to 
 +  * I/O Pin Out: up to 20 mA 
 +  * Digital I/O Pins: 14 (6 support PWM output) 
 +  * Analog Input Pins: 6 (with 10-bit resolution) 
 +  * Flash Memory: 16 kB (ATmega168) or 32 kB (ATmega328) (2kB used by bootloader) 
 +  * SRAM: 1 kB (ATmega168) or 2 kB (ATmega328) 
 +  * EEPROM: 512 bytes (ATmega168) or 1 KB (ATmega328) 
 +  * Serial I/O: 4 UARTs, one SPI and one I2C interface 
 +  * Reset-en jumper, so you can disable auto reset on powerup/USB connection (not on later versions) 
  
 \\ \\
 ---- ----
 ===== Schematics ===== ===== Schematics =====
 +{{electronic:boards:arduino:2009_duemilanove.png?800|Arduino Duemilanove Pinout}} ((from https://web.archive.org/web/20171005020513/http://www.pighixxx.com/test/wp-content/uploads/2014/11/2009.png CCBYSA Alberto Piganti))
 +{{electronic:boards:arduino:arduino-duemilanove-schematic.png?800|Arduino Duemilanove Schematic}} ((from https://www.arduino.cc/en/uploads/Main/arduino-duemilanove-schematic.pdf CCBYSA arduino.cc))
  
 \\ \\
 ---- ----
 ===== Examples ===== ===== Examples =====
 +^Probable Jaycar clone :^
 {{electronic:boards:arduino:pa184370a.jpg?800|Duemilanove overview}} {{electronic:boards:arduino:pa184370a.jpg?800|Duemilanove overview}}
 +{{electronic:boards:arduino:pa204416a.jpg?800|Duemilanove top view}}
 +{{electronic:boards:arduino:pa204417a.jpg?800|Duemilanove bottom view}}
 +
 +^Examples from Wikimedia:^
 +{{electronic:boards:arduino:arduino_duemilanove_0509.jpg?800|Duemilanove top view}}((from https://commons.wikimedia.org/wiki/File:Arduino_Duemilanove_0509.JPG))
 +{{electronic:boards:arduino:arduino_duemilanove_2009b.jpg?800|Duemilanove top view}}((from https://commons.wikimedia.org/wiki/File:Arduino_Duemilanove_2009b.jpg))
  
 ====== References and Additional Resources ====== ====== References and Additional Resources ======
-  *+  * [[https://web.archive.org/web/20140412142538/http://arduino.cc/en/Main/arduinoBoardDuemilanove|Old arduino.cc webpage]] 
 +  * [[https://electricalflux.com/mcu-boards/arduino-duemilanove-ftdi-legacy-board-review-comparison|Info and comparison with Uno]] 
 +  * [[https://awtfy.com/2010/05/27/the-arduino-duemilanove-with-atmega328-and-that-reset-line|Reset enable jumper]] 
 +  * {{https://www.arduino.cc/en/uploads/Main/arduino-duemilanove-schematic.pdf|Schematic}}
  
 <html><small><p>If any referenced page no longer exists, try looking for its URL on <a href="http://archive.org">http://archive.org</a>.</p></small></html> <html><small><p>If any referenced page no longer exists, try looking for its URL on <a href="http://archive.org">http://archive.org</a>.</p></small></html>

Page Tools

electronic/boards/arduino/duemilanove.1792352453.txt.gz · Last modified: 2026/10/18 19:40 by admin
CC Attribution-Share Alike 4.0 International Except where otherwise noted, content on this wiki is licensed under the following license: CC Attribution-Share Alike 4.0 International