Differences
This shows you the differences between two versions of the page.
| Both sides previous revisionPrevious revisionNext revision | Previous revision |
| electronic:3Dprinter [2020/09/17 00:48] – tony | electronic:3Dprinter [2020/09/29 22:48] (current) – tony |
|---|
| * [[https://www.ulule.com/wafate/|Wafate 3D printer from e-waste.]] | * [[https://www.ulule.com/wafate/|Wafate 3D printer from e-waste.]] |
| * [[https://atmelcorporation.wordpress.com/2014/06/02/creating-a-3d-printer-for-under-100/|Poor Man’s 3D Printer.]] | * [[https://atmelcorporation.wordpress.com/2014/06/02/creating-a-3d-printer-for-under-100/|Poor Man’s 3D Printer.]] |
| | * [[https://www.instructables.com/id/DIY-delta-3D-printer-using-low-cost-recycled-parts/|Delta 3D printer using low cost recycled parts]] |
| |
| * [[https://reprap.org/wiki/Build_A_RepRap|Reprap]] | * [[https://reprap.org/wiki/Build_A_RepRap|Reprap]] |
| | * [[https://reprap.org/wiki/Delta_geometry|Delta geometry]] |
| | * [[https://www.researchgate.net/figure/Kinematic-scheme-of-two-manipulating-standard-types-of-robots-SCARA-1-pictured-left_fig1_311098885|Kinematic scheme of two manipulating standard types of robots SCARA]] |
| |
| <html><small><p>If any referenced page no longer exists, try looking for its URL on <a href="http://archive.org">http://archive.org</a>.</p></small></html> | <html><small><p>If any referenced page no longer exists, try looking for its URL on <a href="http://archive.org">http://archive.org</a>.</p></small></html> |
Except where otherwise noted, content on this wiki is licensed under the following license: CC Attribution-Share Alike 4.0 International